Plumbing referrals for Denver & nearby townsCall: (303) 529-9880
(303) 529-9880

Burst Pipe Repair in Pine, CO

plumberdenverco.net

Pine and the historic Pine Grove area sit in the mountains off US 285, where homes rely on private wells. One call reaches a local plumber.

Pipe burst in Pine?
Call now to be connected with a local plumber in Pine.
(303) 529-9880

If a pipe bursts in your Pine home, turn off the well pump, close the main valve and keep away from wet outlets. A plumber can repair the break and check the pressure tank and well line. Call the number on this page to be connected with a local plumber in Pine.

Plumber replacing a split copper pipe in a cold crawlspace, burst pipe repair in Pine, CO

Local conditions in Pine

Pine is a small unincorporated mountain community in southwestern Jefferson County, centered on the historic town of Pine Grove and reached from US 285 at Pine Junction. No public water system was identified for Pine; Jefferson County says mountain-area homes are generally supplied by private wells, and homes here typically aren't on municipal sewer, relying instead on a private onsite wastewater system. That makes a burst pipe here a private matter from the well to the faucet. There's no utility to call, and the first steps are on you: turn off the well pump at its breaker, close the main valve past the pressure tank, and open a low faucet to drain the lines.

Mountain winters are long, and the weak points on a well system include the pressure tank, the pressure switch and the line where the well enters the house, on top of crawl spaces and exterior walls. A pump house or tank closet that loses heat can freeze on a cold night even when the living room is warm. Try not to send a lot of leak water down the drains, which go to your onsite system.

Repair options

ProblemTypical repairNotes
Split supply line indoorsCut out and spliceInsulate afterward
Frozen or cracked pressure switch or tank fittingReplace the partCheck the tank's air charge too
Leak on the buried well lineExcavate and repairRocky ground can add time
Line in an unheated crawl spaceInsulate, heat tape or reroutePrevents a repeat
Call now to be connected with a local plumber in Pine.
(303) 529-9880

Signs to look for

  • Pump running or cycling with every tap off
  • No water after a frigid night
  • Water under the house or seeping from a wall
  • Ice forming on an outside wall

Timing and permits

Breaks often show during the first thaw after a long cold stretch. Pine's ZIP straddles a county line. For Jefferson County addresses, plumbing permits come from Jefferson County Building Safety (303-271-8260). Some Pine addresses fall in Park County, which contracts plumbing permits and inspections to the State of Colorado (303-894-7800). Jefferson County also recommends testing drinking-water wells seasonally and after pump or well work, so test after any repair that opened the well system.

Burst Pipe Repair questions in Pine

How do I stop the water in a home on a private well?
Turn off the well pump's breaker, close the valve on the house side of the pressure tank and open a low faucet. With no utility involved, the next call is a plumber.
Does a burst pipe repair need a permit?
For Jefferson County addresses, Jefferson County Building Safety issues plumbing permits. For Pine addresses in Park County, plumbing permits and inspections are handled by the State of Colorado.
What should I do with the plumbing before a winter trip?
Keep the heat on in the house and any pump house, open cabinets on outside walls, and for a long absence consider turning off the pump and draining the lines.
What should I do about the water heater after a pipe breaks?
Close the water and turn off an electric heater or set a gas unit to pilot. If you smell gas, leave and call 911 and your gas utility or propane supplier from outside.

More plumbing services in Pine

Burst Pipe Repair nearby

Call now to be connected with a local plumber in Pine.
(303) 529-9880

Last updated:

☎ Call (303) 529-9880